Power
CyperPRO comes with a built-in rechargeable lithium-ion polymer battery boasting an impressive 3650 mAh capacity. This allows the device to function continuously for up to one month on a single charge
CyperPRO comes with a built-in rechargeable lithium-ion polymer battery boasting an impressive 3650 mAh capacity. This allows the device to function continuously for up to one month on a single charge. Recharge the battery using the provided USB Type-C cable.
Power On
To power on the CyperPRO device, hold the select button for 3 seconds.
If your CyperPRO fails to Power On
1. Ensure that your CyperPRO may have a fully drained battery. To power it on, connect the USB charging cable, and the device should turn on automatically. 2. If the CyperPRO doesn't respond even after charging, attempt to resolve it by pressing and holding the select button for 10 seconds. 3. If your CyperPRO still refuses to turn on, please refer to the instructions outlined in the Firmware Recovery section.
Power Off
To turn off the CyperPRO device, either hold the select button for 5 seconds or use the software: Main Menu -> Power Off -> Confirm your choice
Charging
To charge your CyperPRO, insert the supplied USB Type-C cable into the charging port and connect it to a power source. A full charge typically takes approximately two and a half hours.
Always use the official charger and cable provided with CyperPRO or a certified replacement. Using standard chargers may not provide the correct voltage, which can be dangerous for both you and the proper functioning of the device !
View information about charging
To access battery information, navigate to the: Main Menu -> Settings -> Battery
Tips & Tricks
Battery life pertains to the duration your CyperPRO runs before needing a recharge, and battery lifespan signifies the length of time your battery remains functional before requiring replacement. To optimize your device's battery performance and extend its longevity, consider the following tips:
1. Manage Screen Brightness: Adjust your device's screen brightness to an appropriate level, as excessive brightness consumes more power. You can find this option in the device settings. 2. Update Software: Keep your device's software up to date. Manufacturers often release updates to improve battery efficiency.
1. Observe the temperature parameters within the specified operational range. CyperPRO is meticulously designed to function optimally under ambient temperatures between 0°C and 40°C. It is crucial to avoid exposing the device to environmental conditions that fall outside of this specified range to ensure compliance with electronic device legal requirements and to maintain its longevity and performance. 2. Once your CyperPRO reaches a full charge, typically around 80-90%, unplug it. Overcharging can strain the battery and reduce its lifespan.
Power system characterictics
• Battery capacity: Indicates the amount of energy the battery can store, typically expressed in mAh (milliampere-hours) or Wh (watt-hours). • Battery life: The duration for which the device can operate on a single battery charge before requiring recharging. • Charge time: The time required to fully charge the battery from complete discharge to full capacity. • Power connector: Specifies the type and kind of connector used for charging the device. • Charging voltage and current: Specifies the voltage and electric current required for effective charging. • Battery operating voltage: The range of voltage in which the battery can operate and supply power to the device. • Maximum USB cable power supply current, including connected devices: Refers to the maximum current that can flow through the USB cable to power connected devices without overloading the system.
Last updated
